Description
Air duct inlet:
In order to transport the air to the brake ventilation outlet, a suitable inlet is essential. The M2 F87 does not have any intake ducts in the front bumper ex works like the M2 Competition F87N. What your car does have, however, are 2 radiators behind the bumper on the side! So why not use the existing air flow?
In order to prevent the air from randomly swirling in the wheel arch after the coolers, we have developed a guide duct that can be installed with minimal effort and guides the air around the wheel connects a connection to the outlet via a 40 cm long hose (per side). Our tests have shown that this does not create significant back pressure behind the radiator and in the event of extreme speeds and increasing pressure, the channels do not present any obstacles to the escaping air behind the radiator.
Air duct outlet:< /p>
For many vehicles (such as the M2), brake cooling is recommended even under medium-heavy loads, even outside the racetrack. This not only improves braking performance, but also drastically reduces wear on the friction partners. Our anchor plate uses the channeling of the air flow to the center of the brake disc to use the turbine effect to cool the disc from the inside. In doing so, we target the windscreen at a defined angle in order to avoid any wastage and to use the available air volume as efficiently as possible. Thanks to the lightweight construction in combination with powdered aluminum, the anchor plate is sufficiently strong and at the same time light and insensitive. In addition, the bearings closest to the brake disc are shielded from the heat to increase their service life (if necessary).
Included in delivery:
1x air duct inlet on the left
1x air duct inlet right
1x air duct outlet left
1x air duct outlet right
1x air hose 1 meter
6x fastening screw< /p>
6x washer
4x hose clamp
Item is suitable for
BMW M2 (not Competition)
For the M2C we also have a suitable kit in the shop:
Carbon brake cooling inlet suitable for BMW M2C set
Motorsport parts without street approval We explicitly point out that none of our products offered for sale, are original vehicle parts from the vehicle manufacturers BMW AG, M GmbH, MINI, VAG or other vehicle manufacturers. Naming the vehicle brands and models only serves to find the product and assign it to the appropriate vehicle type.
The different models vary slightly in the wheel position, coupled with different chassis geometries and wheel and tire combinations, it becomes impossible for us to cover all variants. In the worst case, the wheel could rest slightly at full steering angle (which should only be the case when parking), which could not cause any damage to the tire. In this case we were asked to forego the last ? of the steering turns.
