Description
Air duct inlet:
In order to transport the air to the brake ventilation outlet, a suitable inlet is essential. The E46 M3 already has intake ducts in the front bumper ex works, but these end in the middle of the wheel arch. In order not to randomly swirl the air in the wheel arch, we have developed an extension to the air duct, which can be installed with minimal effort, guides the air around the wheel and connects the air duct to our anchor plate via a 40 cm long hose (per side).
Air duct outlet (anchor plate):
The matching anchor plates for the E46 M3! We use the channeling of the air flow to the center of the brake disc to use the turbine effect to cool the disc from the inside. In doing so, we target the windscreen at an angle that reduces scattering losses and uses the available air volume as efficiently as possible. In addition, the bearings closest to the brake disc are shielded from the heat to increase their service life (only if necessary). Thanks to the choice of material made of powdered aluminum, the component is sufficiently strong and at the same time light and insensitive.
IMPORTANT: The different models vary slightly in the wheel position. Coupled with different chassis geometries and wheel and tire combinations, it becomes impossible for us to cover all variants. In the worst case, the wheel could rest slightly at full steering angle (which should only be the case when parking), which could not cause any damage to the tire. In this case, we would ask you to forego the last ? of the steering turns.
Included:
1x air duct inlet for the front axle on the left.
1x air duct inlet for the right front axle
8x fastening screw with washer
1x anchor plate for the left front axle
1x anchor plate for the right front axle
1x air hose (1 meter)
4x hose clamps
Item is suitable for:
BMW E46 M3
